Atlantic F18 Notice D'utilisation Et D'installation page 10

- There is no point in setting the unit to its maximum, the room temperature will not rise any faster.
- When you air the room, switch the unit off by putting cursor A to
- Remember to lower the temperature if you go out for several hours.
If go out for : less than 2 hours, do not touch the controls.
- If you have several units in the room, let them all operate at the same time, this will give a more uniform temperature without in-
creasing electricity consumption.
WARNINGS
Children must not lean on the appliance. Under certain circumstances, there is a risk that its surface
may cause burns to the skin of young children. If there is any risk of this at all, install a protection grill.
This device is not intended for use by persons (including children) with physical, sensory or mental
disability, or by persons lacking experience or knowledge, unless they have received from a person in
charge of their safety adequate supervision or preliminary instructions on how to use the device.
Care must be taken at all times to keep children from playing with the device.
Do not introduce objects or paper into the device.
Do not totally or partially block the grilles on the front or inside of the appliance, as this may cause
overheating. If the supply cord is damaged, it must be replaced by a service agent or similarly qualified
person in order to avoid a hazard (applies to all units).All work to the inside of the appliance must be
carried out by a licensed electrician.
MAINTENANCE
To maintain performances of your unit, you should clean the upper and lower grilles of the unit about twice a year using a vacuum
cleaner or a brush.
Have a professional check the inside of the unit every five years.
Dirt may collect on the grille of the unit if the atmosphere is polluted. This phenomenon is due to the poor quality of the ambient
air. In this case, it is recommended to check that the room is well ventilated (ventilation, air inlet, etc.), and that the air is clean. The
unit will not be replaced under the guarantee because of this type of dirt.
The unit casing should be cleaned with a damp cloth, never use abrasive products.
If the unit does not heat:
Check that the programmer is in COMFORT mode.
Make sure that the installation circuit breakers are switched on, or that the load shedder (if you have one) has not switched off
the unit power supply. Check the air temperature in the room.
The unit does not carry out programming orders:
Make sure that the programming unit is being correctly used (refer to its user's manual) or that the Chronocarte is properly inserted
in its housing and that it is operating normally (batteries?).
The unit is permanently heating:
Make sure that it is not in a draft and that the temperature setting has not been changed.
This unit with electronic control is equipped with a microprocessor that can be disturbed by some severe mains voltage
disturbances (outside EC standards defining the disturbance protection level).
If there are any problems (thermostat blocked, etc.) switch off the unit power supply (fuse, circuit breaker, etc.) for about 10 minutes
to allow the unit to start again.
Have your energy distributor check your power supply if the phenomenon occurs frequently.
III - R
ECOMMENDATIONS FOR USE
from 2 hours to 24 hours, set the cursor A to
for more than 2 hours or during the summer, put the unit in Frost Free mode.
IV - T
ROUBLE SHOOTING
.
.
9
GB