Aerotec Airliner 2 compact Manuel Utilisateur page 12

Back off vent valve 11 located underneath the
compressor (switched off beforehand) by two
turns, taking care to maintain the compressor
in a vertical position. After draining all the wa-
ter, draw up the valve tightly.
Warning: if the water that condenses is not
drained, it may corrode the receiver, redu-
cing its capacity and impairing safety. As
it is a contaminating product, condensate
must be DiSPoSED of in accordance with
laws on protection of the environment and
current legislation.
The compressor must be disposed in confor-
mity with the methods provided for by local
regulations.
4. inFLAtion Gun
For inflating tires, rubber dinghies, air
beds, footballs and other objects
Warning: Do not direct the jet of com-
pressed air towards people or animals.
Never inflate the objects above the recom-
mended inflation pressure as this may be
dangerous and cause damage and/or in-
juries.
uSE
1. Connect the inflation gun to the compres-
sor as explained in chapter "2 - CON-
NECTING THE ACCESSORIES TO THE
COMPRESSOR".
2. When inflating tires or certain bicycle ti-
res, it is not necessary to insert any of the
adapters (fig. 5). Press tab E (fig. 3) and
connect the hose of the gun to the tire
pushing the fitting on the valve and then
releasing the tab.
3. Inflate the tire pressing lever F (fig. 4).
Release the lever and read the pressure
reached on gauge G of the gun. Repeat
the operation until the pressure required
is obtained. In the case of over-inflation,
press button H to reduce inflation pressure.
Warning: do not hold down the lever
too long before checking the pressure
reached as this could cause explosion of
the object being inflated.
4. When inflating footballs, rubber dinghies,
certain bicycle tires and children's infla-
table swimming-pools, you may have to
use a suitable adapter (fig. 6). Adapter 8
is used for footballs Adapter 9 is used for
rubber dinghies, air beds and children's
swimming-pools Adapter 10 is used for
certain bicycles Select the suitable ad-
apter and push it in the inflation hose
pressing tab E (fig. 6). Once it is inserted,
release tab E. To secure the adapter, turn
it slightly in a clockwise direction
5. Inflate the object concerned as described
in point 3.
tiPS For uSinG tHE inFLAtion Gun
Use the inflation gun at least once every two
weeks in order to check that your tires are at
the right pressure; this promotes fuel economy,
increases the service life of your tires and im-
proves safety as it reduces braking distances
and improves handling of the vehicle.
mAintEnAncE
Do not clean the inflation gun and adapters
with solvents or flammable or toxic liquids.
5. BLoWEr Gun
Warning: it is advisable to wear safety
goggles when using the blower gun.
Do not direct the jet of compressed air
towards people or animals. take care not
to blow dust and dirt towards yourself or
other persons.
uSE
1. Connect the blower gun to the compres-
sor as explained in chapter "2 - CON-
NECTING THE ACCESSORIES TO THE
COMPRESSOR".
2. Set operating pressure to the value indi-
cated for this accessory (see table 1).
3. Direct the blower gun towards the surface
to be cleaned and press the lever F (fig.
7). The flow of air can be regulated accor-
ding to how far you press down lever F.
tiPS For uSinG tHE BLoWEr Gun
TClean the carpets of your home or car mats
very efficiently using the blower gun. It is also
ideal for keyboards, electrical items, refrigera-
tors, cameras, TV cameras, glassware and the