GD Import 134565 Mode D'emploi page 2

 Ne pas utiliser la poignée si il y a des signes de dommages.
 Ne pas utiliser d'objets pointus ou tranchants pour libérer la ventouse de la surface.
 Utiliser la poignée seulement sur des surfaces planes, solides et lisses comme le carrelage, le verre,
le plexiglas ou en fibre de verre
 Vérifiez que la poignée soit montée correctement avant utilisation et que le levier de verrouillage soit
dans la position «fermée» .
 Ne laissez pas la ventouse fixée sur une surface pendant une période prolongée car le
maintien se détériorera.
GB - Suction cup hand rail
Caution:
To be used as balancing assist only-do not use to support your
Full body weight- not intended to support full body weight.
You must test the safety grip handle before each use. It must be checked periodically for tightness.
As this is a safety support item, we advise anyone having any difficulty following these instructions to
use the services of a qualified installer.
Please note:
For maximum support this item must be used correctly. Incorrect usage may cause the bath safety grip
handle to loosen and not provide stability.
The suction cups must be over a completely smooth non-porous surface. Placing suction cups
over cracks or grout lines between tiles will prevent them from holding properly and the item
will be unstable.
Safety Information: Must be mounted to a clean, smooth, flat, non-porous surface. Used as balance
assist only not for body weight leverage. Always make sure bar is securely attached before each use
and reattach if loose.
Directions: Clean and wet the surface the bar is to be mounted to. The tilting levers must be up and
loose (1). Press the rubber discs on to the surface, the whole of each disc must be completely on the
surface. Press the tilting levers down on each of the discs. Test the adhesion. If loose reposition and try
again. To remove flip tilt levers up and slip fingertip under each disc to release suction. Check adhesion
before every use: clean the surface and the suctions and reposition when necessary. Uninstall and
reinstall every week. For pulling up: Max pressure: 50Kg
THE PULLING MUST BE PERPENDICULAR TO THE GRIP LIKE ON FIGURE 1
NOT PULL STRAIGHT UP AS THIS CAN CAUSE UNDERCARRIAGE DAMAGE.
TO PUT THE GRIP ON A WET SURFACE MAY CAUSE SLIDING OR TAKING DOWN.
Never use the suction grip on rough and/or porous surface, wood, painted walls or other finished
surfaces. Never use the suction grip on moving surfaces. When placing the suction grip on not cleaned
and not suitable surfaces, there is risk of injury!
§ Do use the suction grip when there are signs of damage.
§ Never use sharp objects to release the suction pillow from the surface.
§ Only use the suction grip on smooth, level and clean surfaces such as tiles, glass, acrylic glass or
fiberglass.
§ Always check for the suction grip to be properly placed on the surface, and before usage check for
the locking lever to be safely in the "locked position".