Maintenance; Troubleshooting - Uberhaus 10635000 Guide De L'utilisateur

is corrected, wait 10 minutes for the unit to cool down. After 10 minutes, plug the
unit in again and operate normally.
8. Turn off the product by rotating the thermostat knob to the "
unplug the product from the electrical outlet.
WARNING: Always unplug the product when it will be left unattended or not in use.
NOTE: This appliance are fixed with 3-prong plug, you should follow as shown
below:

MAINTENANCE

WARNING: Do not attempt to disassemble this product for any reason, as incorrect
re-assembly could cause a risk of fire or electric shock. Only qualified service
personnel should perform any servicing.
WARNING: Always unplug the product from the electrical outlet and allow it to cool
before cleaning or storing it.
NOTICE: This product is permanently lubricated at the factory before shipping and will
not require further lubrication for the life of the product.
• Clean the exterior surface by wiping with a soft, damp cloth, and allow the product to
dry completely before storing or using. Dust can be removed from vents using a small
vacuum.
• To store, wind and secure the power cord using a twist tie or rubber band, and place
the product in a cool, dry location.
WARNING: Do not allow water or other liquids to enter the interior of the
product. Do not use abrasive cleaners/pads to clean the product.

TROUBLESHOOTING

Page 6
" position, and then