Assembly Instructions; Operating Instructions - Uberhaus 10635000 Guide De L'utilisateur

ASSEMBLY INSTRUCTIONS

Attach the handle (B) to the top of the heater (A) with the two screws (C) provided
using a Phillips screwdriver (not included).

OPERATING INSTRUCTIONS

1. Place the product upright on a flat, level, stable, heat-resistant
surface. Plug the power cord into a standard 120-volt electrical
.
outlet The power indicator will illuminate, indicating the heater
(A) is on.
2. Main Control Knob (Figure 1): Use this button to set the heat
setting:
Ⅰ (1,300 W) – Low heat setting
Ⅱ (1,500 W) – High heat setting
3. Turn the thermostat control knob clockwise to adjust the room
temperature
4. Allow the product to operate until the room temperature
reaches the desired comfort level.
5. Slowly turn the thermostat control knob counter-clockwise
until heater turns off. The heater will cycle on and off to maintain
the setting.
6. To adjust the thermostat, turn the thermostat control knob toward high to increase
the set ambient temperature and toward off to decrease it.
7. When the unit has been overheating, the thermal cut-out trips, the unit needs to be
reset. Before resetting the unit, turn the control knob to
Check if the air vents are blocked or if there is another problem. Once the problem
Page 5
and unplug the heater.