Filling The Water Tank - Makita DT4000 Instructions De Montage

Adjusting the cut depth limiter
Swinging the wheel (4) in the desired direction to adjust the
cutting depth
- To do this, loosen the quick action lever (16) and retighten
after adjustment.
Note: The quick action lever (16) can be brought into the de-
sired position by pulling it the direction of the arrow and then
turning.
Pulling the quick action lever releases the screw. It can be
tightened again by "returning" the lever.
Mounting watertank
- Put the water tank (5) in the tank holder (3).
- When the Power Cut is assembled the hose (8) will go
along the side of the Power Cut and attach to the water set
coupling.
Filling the watertank
- Before Þ lling the water tank, detach the hose (8) from the
water set coupling and take the water tank out of the tank
holder, unscrew cap (9) and Þ ll with clean water. Do not
allow dirt to get into the tank, as it could block the sprinkler
nozzles.
Starting
- Start the Power Cut as described in the operating manual.
- Press the button (24) and then move the bar (25) to the
handle in the direction shown by the arrow.
Caution: The Power Cut will start immediately!
Note: The Power Cut trolley has a dead-man switch. If the
bar (25) is released all the way, the Power Cut will go to idle
immediately.
If the button (24) is not pressed, it is still possible to move
the bar (25) but the Power Cut will only run in idle. To resume
operation it is necessary to release the bar (25), press the
button again (24) and then pull the bar (25) back to accelerate
again. Always perform these actions in this sequence (24,
25)!
Adjustments
Adjusting the cutting line
If the guide trolley pulls to the left or right of the straight cutting
line when you are cutting with the power cut, this can be cor-
rected by pushing aside the support plate (21).
- Loosen the nuts on the screws (22).
- Loosen the quick-action lever (16).
Pushing the support plate (21) in the direction A corrects
cutting to the left.
Pushing the support plate (21) in the direction B corrects
cutting to the right.
8
4
16
9
25
24
16
21
A
5
3
8
22
B