Jung 500.600.035 Instructions D'utilisation page 5

eNet capteur d'énergie radiofréquence 1 voie mini
Advanced device settings
Parameters
Manual commissioning
Repeater mode
Transmission mode
Channel settings
Parameters
Active energy
Extended channel settings
Parameters
Manual commissioning
Transmit voltage
Transmit current
Transmit effective power
Transmit reactive power
82581513
J0082581513
Setting options, Basic set-
ting
On, Off
Basic setting: On
On, Off
Basic setting: Off
Single, Double
Basic setting: Double
Setting options, Basic set-
ting
-1073741823...1073741823
Wh
Basic setting: 0 Wh (Current
value)
Setting options, Basic set-
ting
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
5/7
Explanations
Disables manual commissio-
ning for all device channels. In
the "Off" setting, the device
cannot be reset to the factory
setting.
In addition to its other func-
tions, the device can be used
as a repeater. In the "On" set-
ting, the device repeats all the
received telegrams.
The transmission of all measu-
red value telegrams is repea-
ted to guarantee increased
transmission security (no un-
secured transmission). It is
possible to switch over to
simple transmission.
Explanations
Displays the currently cumula-
ted active energy. The value
can be reset to 0 or set to any
other value.
Explanations
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device can-
not be reset to the factory set-
ting.
Transmits the current voltage
value.
Transmits the current current
value.
Transmits the average effec-
tive power. If negative values
are displayed, then effective
power is fed in, e.g. via a pho-
tovoltaic system.
Sends the current fundamen-
tal oscillation idle power value.
If negative values are dis-
played, this is capacitive reac-
tive power. Positive values
show an inductive reactive po-
wer.
11.04.2017