Inventum MC 30 Mode D'emploi page 25

H – Cuticle pusher
Soften the cuticle with water or cuticle oil. now you can push back or remove the cuticle. Depending on
the sensitivity and stubbornness of the skin, you can either use the soft, rounded side or the harder
pointed side.
When filing, always work from the outside of the nail towards the tip! Always check results
regularly during treatment. As soon as the application becomes unpleasant, stop the treatment.
C – Sapphire disk, fine
Filling and treatment of the nails, fine grained sapphire disk. The specific aspect
of this sapphire disk is that only the inner disk rotates, while the outer support is
stationary. This enables precise filing of the nails without the risk of burning the
skin with the fast rotating disk.
D – Sapphire callus rasp
For rapid removal of stubborn calluses and hard skin on the soles of feet and
heels. This attachment can be used on large areas.
E – Cylindrical milling cutter
Grinding of lignified foot nail surfaces as well as smoothing of these. For this
purpose, apply the milling cutter horizontally to the nail surface and remove the
unwanted layer of nail using slow circular movements.
F – Flame milling cutter
For removing ingrown nails. Carefully guide the flame cutter up to the part to be
treated and remove parts of the nail as neccessary.
G – Sapphire milling cutter, round
This accessory attachment is for careful removal of corns. when using this
attachment, please remember when removing the layer of skin from the corn
that you will quickly penetrate deeper into the skin and this could injure the
periosteum.
25