Operating Instructions; Switch Module Ms - HumanTechnik MS-1 Mode D'emploi

We would like to congratulate you on
the purchase of our switch module
MS-1 and hope that it will serve you
well for a long time to come.
You have chosen a mo dern and reliable
system. Please read the operating
instruction through carefully to be
able to start the unit correctly and to
familiarize yourself with all of the sys-
tem features.
With the switch module MS-1 you can
extend every unit that has a connector
socket (3.5 mm jack) for the vibrating
pillow with a 230 V switched socket.
Standard components
Please check if all following compo-
nents are included:

- Switch module MS-1

- Connecting cable
- Operating instruction
- Warranty card
If any parts are missing please imme-
diately contact your dealer or the
manufacturer directly.
Installation
Attach the connecting cable to one of
the two connector sockets for the sig-
nal source at the back of the switch
module MS-1 . Plug the other end of
the cable into a unit with a connector
socket for a vibrating pillow e.g. alarm
clock DS-1, VC-1/VC-10, time flash /
lisa time flash , lisa receivers (table
flash lamp, RF flash lamp, RF blink
lamp, mobile RF receiver).
Plug the plug of the switch module
MS-1 into a 230 V mains socket and
a lamp into the switched socket of
the module. Please make sure that
the lamp is switched on.
The lamp can be switched on and off
with the switch at the front of the
switch module MS-1 .
Note
A vibrating pillow or another module
(e.g. acoustic module) can be plugged
into the empty connector socket at the
back of the switch module MS-1 .
Signalling
Upcoming signals (e.g. wake-up
alarm, lisa alarm) are signalled by the
lamp being switched on and off.
English 7