Service And Warranty - IRIMO 3.6SDR Traduction Du Manuel D'origine

3.6SDR
Charging
The battery-operated screwdriver has not been fully
charged at works. Before using for the first time charge
the screwdriver unit for 3-5 hours. To do this insert the
charger plug (12) into the charging socket (10) and
connect the charging. unit (11) to a power supply.
Lithium battery
Always chargeable. No memory effect. No self
discharge.
Care!
Do not exceed the maximum charging time of 8 hours,
as there is a risk of overheating!
Reccomendation
Connect the unit up to a time switch.
Operation
Insert the screwdriver bit into the bit holder (1) as far
as the stop. If standard bits or socket-driver bits are
used, use an additional bit holder. Before switching on
the screwdriver unit locate the screwdriver bit firmly on
the screw and switch on the unit to rotate in the desired
direction (3), push the Forward/Reverse Switch (2) to
operate the screwdriver.
Angle adjustment
The screwdriver has 2 angle position adjustment, press
the lock switch (6) to get the appropriate angle position
you need, the hinge allows the screwdriver handle to be
angled for better power transmission.
Battery power indicator
The screwdriver has a battery indicator, it is very easy
to show the battery capacity, only need to press the
button (7) when you want to check it, green/yellow/red
light showed the battery power full or low.
Light
The screwdriver has a light, to lighten the place where
you will screw (5).
Extra light
To turn the flashlight, click on (8).
Adjusting the torque setting, helps you in
screwing operations (6+1 positions)
To screw: adjust on the positions (9) from 1 to 6. In
position 1 there is the lower torque, in position 6 there is
the max. torque. Start screwing operation with a lower
4
ENGLISH
torque, then increase it until reaching the necessary
torque.
Care and maintenance
Clean the housing only with a damp cloth - do not use
any solvents! Dry thoroughly afterwards. In order to
maintain battery capacity, we recommend the battery
to be completely discharged every 2 months and
recharged again. Only store full charged batteries.
They should be stored in a dry and frost-free place, the
ambient temperature should not exceed 50 °C.
Important: Protect environements
Do not throw used NC batteries into fire or water; risk
of explosion!
Service advices
Store the machine, operating instructions and the
accessories in the original packaging. In this way you
will always have all the information and parts ready to
hand.
DISPOSAL ONLY FOR EUROPEAN UNION
COUNTRIES (EU)
The product cannot be disposed as
unsorted municipal waste. It must be
collected
negative environmental impacts. In
accordance with the procedures of
Directive 2002/96 CE and relevant
national laws and regulations adopted
pursuant to this Directive on the disposal of waste at the
end of the life cycle of the product, any violation is
sanctioned by law. Please inform yourself about the
local separate collection system for electrical and
electronic products.
SERVICE AND WARRANTY
This product is guaranteed in accordance with statutory
country specific regulations. Damage due to normal
wear and tear, overload or improper handling will be
excluded from the guarantee.
This product is in conformity with the following
regulations and related standards:
EN 60745-1, EN 60745-2-2, EN 55014-1, EN 55014-
2, EN 61000-3-2, EN 61000-3-3: 2006/42/EC, 2014/30/
EU.
separately to prevent