Features; Assembly; Operation - RIDGID R8694620 Manuel D'utilisation

FEATURES

PRODUCT SPECIFICATIONS
LED ........................................ 20 Watts Total (5 Watts/LED)
Light Output ................................1200 Lumens (Maximum)

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not direct the light beam at persons or animals
and do not stare into the light beam yourself (not
even from a distance). Staring into the light beam
may result in serious injury or vision loss.
WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purpose listed below:
 General illumination of most work areas
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 7.
 Align the raised rib on the battery pack with the groove
inside the flood light, then slide the battery pack into the
flood light.
Maximum Runtime ........................ Approximately 20 hours
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
flood light before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
ATTACHING THE WORKLIGHT TO THE STAND
See Figure 2, page 7.
 Align the raised rib on the flood light with the groove in the
stand's cradle, then insert the flood light into the cradle
until it clicks into place.
NOTE: The flood light is designed so that it will only install
into the cradle one way.
 Depress the release button to remove the flood light.
ADJUSTING THE FLOOD LIGHT POSITION
See Figure 3, page 7.
When the flood light is attached to the stand, it can be
rotated 360 degrees. Adjust light to desired position to best
illuminate the work area.
OPERATING THE FLOOD LIGHT
See Figure 4, page 7.
Push the on/off/brightness knob to turn the flood light on
and off.
To increase brightness: turn the on/off/brightness knob
clockwise.
To decrease brightness: turn the on/off/brightness knob
counter-clockwise.
5 - English