Opening The Unit - Knick VariTrans P 27000 Notice D'utilisation

3. Configuration (P 27000 F1 and P 27000 H1 only)
3.1 Tools
A screwdriver with a width of 2.5 mm is required to open and adjust the unit
and to connect the wires to the screw clamp terminals.

3.2 Opening the unit

Disengage the top part of the housing on
both sides using the screwdriver.
Pull out the top part of the housing and
the electronics section until they lock.
3.3 Settings
Set the input and output ranges, offset and
bandwidth using DIP switches S1, S2 and S3
as indicated in the following tables. When
selecting a variable gain or offset setting, an
additional setting can be made using the
Span (gain) or Zero (offset) potentiometers
accessed from the front.
Caution!
Only use a screwdriver which is
properly insulated against the
voltage applied to the input when fine
adjusting the potentiometers on the
front.
29