edc LIMPET Guide D'installation Et D'utilisation page 4

Installation
The LIMPET can be installed on the left or right hand side of the air handler.
The following installation instructions refer to a right handed installation. For left handed
installations swap the positions of the pump and condensate collection tray as shown
below.
Left Handed
Right Handed
Fig.2. Cut the drain hose level with the
bottom of the bracket.
Fig.4. Slide the filter over the pump inlet
tube and fit the condensate collection
tray onto the backplate.
Fig.1. Screw the backplate to the wall
3 mm below the air handler and just
overlapping the outlet hole. Enlarge the
outlet hole if necessary.
Fig.2
Fig.3. Place the LIMPET pump on the
mounting posts, feed the power cable
through the air handler outlet hole and
connect the discharge tube.
Fig.4
Fig.5. Slide on the cover and snap into
place.
3mm
GB
Fig.1
Fig.3
Fig.5
3