Dimensions - Balluff BAE PS-XA-1S-24-200-104 Notice D'utilisation

Switching mode power supplies IO-Link ready
BAE PS-XA-1S-24-200-104
Installation (continued)
Internal fuse
The internal input fuse protects the device and cannot be
replaced. If an internal fault occurs, return the device to the
manufacturer as a precautionary measure.
Rail mounting
The power supply unit should be mounted on 35 mm DIN
rail in accordance with EN60715.
Provide sufficient ventilation and cooling. Do not block any
ventilation openings.
1. Slightly tilt the device to the rear and hook the device
to the upper edge of the rail.
2. To latch, rotate the device downward until the clip
engages and snaps to the bottom edge of the rail.
3. Move the device gently to verify latching.
Removal
DANGER
Stored energy
Risk of electric shock from stored energy.
► Wait 5 minutes after disconnecting all sources of
supply before accessing.
1. Switch off the power supply and disconnect the sys-
tem from mains. Disconnect all connectors from the
power supply.
2. Slide the latch guard down (unlatch).
3. Slightly raise the front edge of the device (tip) and
remove.

Dimensions

Fig. 3: Dimensions
www.balluff.com
Accessory for IO-Link connection
IO-Link Clip-On
BAE SC-AE-I01 (order code BAE00TF)
The Clip-On is a plug-in IO-Link terminal, having the fol-
lowing functions:
– Transferring process data from the power supply to a
controller via IO-Link
– Turn the power supply off and on via IO-Link
Fig. 4: IO-Link Clip-On
english 3