Zircon LASERVISION 6.0 Mode D'emploi page 14

• Open the battery module by lifting up on the door so it hinges outward.
• Remove the dead batteries and insert the new batteries, negative (-) end side
first, and close the battery compartment cover (Figure 16 below).
• Replace the end cap.
Figure 16: Replacing the Batteries in the Laser Module
The Audio Feature
The LaserVision's audio tone sounds near level or plumb, which is useful in "blind"
situations. It is activated when level or plumb is within the center three bars.
• The audio feature can be turned off by quickly pressing the ON/OFF button
twice when turning on the LaserVision. When the audio mode is off, the
sound icon found on the bottom right of the LCD disappears.
• To turn the sound back on, turn the LaserVision off and on again.
The Backlight (LaserVision 7.0 only)
The LaserVision 7.0 has been equipped with a backlight for use in
low-light situations.
• To turn on the backlight (after turning on the LaserVision level), press and
hold the SLOPE button for two seconds (Figure 17, page 15).
• To turn off the backlight, press and hold the SLOPE button for two seconds
(Figure 17, page 15).
NOTES: 1. Unless purposefully turned off, the backlight automatically lights the
next time the LaserVision is turned on.
2. To obtain maximum battery life, it is recommended that the backlight only be
used when needed for operation in low-light.
14