Special Functions; System Configuration - Watts MASTER 6 ZONES RF Guide D'utilisation

8. SPECIAL FUNCTIONS

Pump Delay
To avoid pump damage and noise in hydraulic circuit (Water flow in the pipe) the start-up of the pump will be
delayed for 1 minute after a heating demand from the zone thermostats. This time will permit to jump the opening
time of the thermal actuators.
Note: if no demand on any zones (actuators) during 24h, the pump output will be driven during 1 minute at 12H00
(so correspond each day 12Hours after first power up)
Valve exercise:
To avoid valve jammed, each valve is activated for 5 minutes every day.
Erase thermostat function:
With this function you could remove one or several thermostats of your installation.
Once on the "RF init" menu, choose the zone which must be removed with the blinking cursor and press 5
seconds in the same time the (◄) or (►) keys. Then the LED(s) of the zone(s) which worked with the thermostat
will be removed.
Factory settings function:
Use this function to erase all configurations and download the factory settings.
Once on the "RF init" menu, press in the same time during 5 seconds the 2 keys (◄) and (►). Release the keys
only when all LED are blank, after few seconds all LED must flash in green. Then the product has been reset.

9. SYSTEM CONFIGURATION

Antenna
Relay pump is activated when there is
one zone activated at least.
(If BT-M6Z02 RF is master, relay pump
is activated if there is one zone activated
ON
at least on the global network.
If BT-M6Z02 RF is slave, relay pump is
activated if there one zone of slave
network activated at least.)
OFF Relay pump is not used
Switch 1 Switch 2
Outputs are There is a pump
normally opened
Outputs are There is no pump
normally closed
8
ON
OFF
ON
OFF
Switch 3 Switch 4
Not used
exercise.
Not used
exercise