Assembling The Stand - Artesia F-61 Mode D'emploi

Assembling the stand:

Begin assembling the piano by attaching the legs of the
stand to the crosspiece:
Insert 2 (E) bolts into each side of the crosspiece. Screw
bolts into the brackets on each leg, make sure that the
crosspiece and the feet are all facing toward you. Tighten
until the crosspiece is flush with the leg brackets, and the
legs are firmly attached.
Attach the piano body to the stand using four (F)
bolts. With help from another person, lift the piano
onto the stand. Rest the piano on the stand and line
up the corresponding holes in the bottom of the
piano with the holes in the brackets on the leg.
Make sure that the piano and legs are facing the
same way. Tighten (F) bolts into each hole until the
piano sits flush on the legs and is firmly attached.
Assembly the bench:
The bench is assembled using kernel locking nuts.
Insert a kernel screw into the four holes in the
bottom of the seat, and two center holes in each
leg. Tighten with a screwdriver. Insert a locking nut
into each hole in the back panel. Insert the two
screws from each leg and tighten the locking nut to
secure. Repeat this step to attach seat.
Finish assembly by covering the locking nuts with
plastic (C) covers
Check piano and seat for stability and proper assembly before using it.
Artesia F-61