Jung FM ES 3680 UP Instructions D'utilisation page 5

eNet
Capteur d'énergie radiofréquence
Manual commissioning
Repeater mode
Transmission mode
Settings, channel
Parameters
Manual commissioning
Transmit voltage
Transmit current
Transmit effective output
Transmit apparent output
Transmit idle output
Transmit absolute effective
energy
Effective energy
82581503
J:0082581503
On, Off
Basic setting: On
On, Off
Basic setting: Off
Single, Double
Basic setting: Double
Setting options, Basic set­
ting
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
On, Off
Basic setting: On
­1073741823...1073741823
Wh
Basic setting: 0 Wh (Current
value)
5/8
Blocks manual commissioning
for all device channels. In the
"Off" setting, the device can­
not be reset to the factory set­
ting.
In addition to its other func­
tions, the device can be used
as a repeater. In the "On" set­
ting, the device repeats all the
received telegrams.
The transmission of all measu­
red value telegrams is repea­
ted to guarantee increased
transmission security (no un­
secured transmission). It is
possible to switch over to
simple transmission.
Explanations
Blocks manual commissioning
for the device channel. In the
"Off" setting, the device can­
not be reset to the factory set­
ting.
Transmits the current voltage
value.
Transmits the current current
value.
Transmits the average effec­
tive output. If negative values
are displayed, then effective
output is fed in, e.g. via a pho­
tovoltaic system.
Transmits the current appa­
rent output value.
Transmits the current value of
the basic oscillation idle out­
put. If negative values are dis­
played, this is a capacitive idle
power. Positive values show
an inductive idle power.
Transmits the cumulative va­
lue of the effective energy. If
negative values are displayed,
then effective energy is fed in,
e.g. via a photovoltaic system.
Displays the currently cumula­
ted effective energy. The va­
lue can be reset to 0 or set to
any other value.
14.03.2014