Schwaiger HDFS100 511 Mode D'emploi Et Consignes De Sécurité page 15

5. The remote controller has to be used within the distance of (from
remote control to receiver) not less than 0.3M and no more than
5M (working angle +/- 15 degrees).
B. TX & RX Pairing MODE
1. First Press "MODE" key on the Receiver BOX.
2. You will see message "Connecting through Pairing ..." on screen
3. And then Press "MODE" key on the Transmitter BOX.
4. for a second, and wait for Atuo connection.
C. IR Extending function
1. Make sure the IR emitter Probe have been installed properly on the
Transmitter Box.
2. Make sure the IR receiver Probe have been installed properly on the
Receiver Box.
3. Use the remote controller of your source device to control the source form
the Receiver Box.
Note
Please do not cover both HDFS100 Transmitter and Receiver with
any object. Because those object could block the air circulation.
TROUBLE SHOOTING
1. When there is no picture presented, please:
• Make sure the direct connection from source device to sink de-
vice can work properly.
• Check if all connectors are connected well; check if all cables can
support the transmission speed. High Speed HDMI cables are rec-
ommended.
• Unplug the power cable to restart HDFS100.
USER GUIDE
15