Silverline 196512 Mode D'emploi page 8

GB
Maintenance
WARNING: Always disconnect from the air supply and depressurise before
cleaning or carrying out any maintenance.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear
quickly, and shorten the machine's service life. Clean the body of your machine
with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should
be noted that when an air tool fails to work it is generally because the internal
workings have corroded due to dirty, wet air and failure to follow the instructions
given below.
Daily maintenance procedure: Disconnect from the air supply, pour the
equivalent of a tablespoon of oil into the air intake. Operate the machine at low
speed to thoroughly lubricate all internal workings.
• If the machine is in constant use or used for long periods at a time, a combined
filter/lubricator must be fitted. There must be an air filter fitted at all times
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
• Failure to comply with the operating and maintenance instructions may
invalidate the guarantee
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Troubleshooting
Symptom
Tool operating slowly
Tool seized
Strong vibrations when tool is
switched on
Tool will not stop after trigger is
fully released
8
Possible Cause
Pressure incorrect
Dirt within the mechanism
Air blockage
Air leak
Blockage in gauze mesh filter
Dirt or rust in mechanism
Dirt or rust in mechanism
Dirt or rust in mechanism
Disc fitted incorrectly
Disc damaged (cracks, deformations or splinters)
Flange damaged (burred or notched)
Spindle bent
Throttle valve O-ring or valve seat damaged
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Disposal
• As with other power tools, air tools should not be disposed of with household
waste
• Air tools may contain traces of tool oil and other lubricants and so must be
recycled accordingly
• Contact your local waste disposal authority for information on the correct way
to dispose of power tools
Solution
Set the correct air pressure according to the specification
Pour oil into air inlet as per maintenance instructions
Operate tool in short bursts to clear blockage
Check all fittings and hose for air leaks and correct issue by
re-tightening, using PTFE tape or replacing
Remove Quick Connector and clean mesh filter
Try 'Tool operating slowly' solutions
Tap tool gently with a soft mallet
Free mechanism by rotating drive manually when disconnected from
Remove disc, inspect for damage and refit
Replace cutting disc
Replace flange
Have the tool repaired by an authorised Silverline service centre
Have the tool repaired at an authorised Silverline service centre
air line