Troubleshooting Guide; Technical Specifications - Igloo Iceless 26 Manuel D'utilisation

8
En

Troubleshooting Guide

Symptom Observed
Unit is Not Cooling Properly
Unit Does Not Run
Cord Gets Hot In the Socket

Technical Specifications

DC USE:
Voltage:
Current Draw:
Refrigeration System:
Cooling Range:
Insulation:
Fan Motors:
Working Current, Battery Consumption:
Fuse in DC Cable
AC USE:
Voltage
Limited Warranty
Igloo Products Corp. warrants the Iceless™ to be free from defects in
material or workmanship under normal use and service for one year from
the date of original purchase. This warranty is your exclusive warranty and
there are no warranties which extend beyond the description on the face
hereof. Igloo, in its discretion, shall either repair the product free of charge
or provide you with a replacement product if the product proves defective
under the terms of this warranty. The warranty is valid for the original retail
purchaser and is not transferable. Dealers, service centers, or retail stores do
not have the right to change the terms and conditions of the warranty. Igloo
is not responsible for incidental or consequential damage resulting from any
malfunction. The warranty shall not apply to any unit, or component thereof,
which is not returned as stated below and/or which has been: (1) damaged
through abuse, misuse or neglect, (2) damaged in an accident, (3) used for
any purpose not expressly stated in this manual, (4) repaired or altered in any
way, including electronic changes from its original configuration. The product
is designed for a 12-volt DC vehicle system and household 110/120-volt (U.S.
and Canada) or 220/240-volt (Europe) AC Systems. Any implied warranties
including the implied warranty of merchantability are also limited to duration
of one-year from the original purchase date. Please carefully review the care
instructions for proper use and care of the product. Please visit our website
at www.igloocoolers.com or www.igloo-store.com for more information.
What To Do
Ensure that air vents are not blocked, remove any obstructions, dust or debris.
Ensure that unit is not sitting in direct sunlight, move to shady place.
Ensure that unit is not too close to a wall or in an enclosed place, move to open area with
adequate ventilation.
Ensure that cord is firmly plugged into power source.
Fuse in DC cable may need replacement – refer to item #4 in Maintenance Procedures
section.
Check for dirt, corrosion or tobacco particles in the socket. Clean/remove debris to ensure
snug fit of plug into socket.
If fuse was replaced, ensure that the power cord was reassembled correctly. Refer to the
diagram on page 6.
12-volts DC
6 amps maximum at 12-volt DC
Thermoelectric solid heat pump
Cools to 20ºC (36ºF) below ambient temperature
Ultratherm® (polyurethane foam)
12-volt DC, dual brushless motors
Between 4.0 to 4.8 amps
7.5A fuse
110/120VAC (U.S. & Canada); 220/240v AC (Europe)
HOW TO OBTAIN WARRANTY SERVICE: DO NOT RETURN PRODUCT TO
THE PLACE OF PURCHASE. If this product fails due to defects in material
or workmanship, you must submit a claim as follows: Call Igloo Products
Corp. Consumer Service toll-free at 1-800-364-5566 (U.S.) or 1-800-500-5447
(Canada) for instructions on return of product. IN ORDER TO OBTAIN
WARRANTY PERFORMANCE, YOU MUST RETURN THE PRODUCT,
INCLUDING ANY COMPONENTS OR ACCESSORIES, AS INSTRUCTED BY
CONSUMER SERVICE, ALONG WITH PROOF OF PURCHASE AND A BRIEF
DESCRIPTION OF THE NATURE OF THE DEFECT.