Publicité
Les langues disponibles
Les langues disponibles
The OMNIPRO+ antenna must be installed outdoors. It can be fixed temporarily or permanently on the roof of
a house or vehicle.
1. Choose the best location taking into account the following conditions:
•
Highest flat surface
•
For installation on a vehicle, do not exceed the vehicle gauge
•
Avoid any obstacle that could disturb the reception by keeping it as far away as possible from
metal masses, electrical devices, etc....
2. Fix the holder / foot with 4 screws (not supplied) adapted to the fixing material (Fig.1). It is possible to
add a glue mesh adapted to the holder (Fig.2)
3. Now assemble the rest of the elements using the tube to connect the two supports. Tighten the 2
screws of the holder (3 Fig. 4) so that they form a single block.
1
NB: The coaxial cable can exit the antenna base either through the central part (1 in Fig. 3) or through the side
exit provided for this purpose (2 in Fig. 3).
In the second case, provide for an additional hole (⌀ 8mm) for the coaxial cable to pass through. Remember to
seal the hole in the cable passage with silicone gasket.
4. Before connecting the coaxial cable from the antenna to your TV or DTT adapter, please make sure
that the +5 Volt antenna option is activated (refer to the user manual of your TV or DTT adapter).
Connecting the antenna with this active function could cause irreversible damage to your equipment.
Installation
Caution: do not screw with a power tool
Fig 1
2
Fig 3
Fig 2
3
English
Location for
gluing
Fig 4
Publicité
