Connection - Renkforce PAS15A Mode D'emploi

8. Connection

The subwoofer is equipped with a jack-plug XLR combination connection for the input and a XLR connec-
tion for the signal output.
When connecting, make sure that the connection cables are not squeezed or damaged by sharp
edges.
The input must only be connected to a low-level audio output of an audio device. The output
also must only be connected to a low-level audio input of an audio device.
The subwoofer and the devices it is connected to must both be switched off during connec-
tion.
Only connect the device with suitable shielded connection cables. Use of any wrong cables
may cause interferences.
To avoid distortion or mismatching that may damage the subwoofer, only an audio device with
a jack plug or XLR output must be connected to the input. Only an audio device with an XLR
connection must be connected to the output.
• Connect the LINE IN (2) to the pre-amplifier or subwoofer output of the advanced audio device (e.g.
mixer).
• The connection LINE OUT (8) can be connected to the audio input of another device if required (e.g.
another subwoofer).
23