Data Output; Connector; V:pad; V:3D - Oase WECS II 2048/DMX/02 Notice D'emploi

- EN -
7.2

Data output

7.2.1

Connector:

Will send out the merged DMX-Data to the physical XLR DMX-Outputs on backside.
7.2.2

V:PAD

This option can be used to send back DMX-Data to VPAD, i.e. if you want to record an incoming DMX-
Signal in a show (Recording old shows). See V:PAD and V:3D
7.2.3

V:3D

This is used to send DMX Data to a PC where V:3D is running in Network, i.e. for monitoring. See V:PAD
and V:3D
7.2.4

ArtNET:

Here you can define one or multiple ArtNET Nodes which should receive the DMX-Data of the current
DMX line. Note that ArtNET Universes are counted by 0.
7.2.5

WECS II 512/DMX/02 Server

Same as by ArtNET you can define one or multiple WECS II 512/DMX/02 Server devices in the Network
to work as DMX Interfaces.
7.2.6

Transform all Input Data with Patch

This option is enabled by default and will calculate all incoming DMX signals depending on the current
patched fixtures, which means that in case of any Profile or Virual Master is assigned to a channel, this
will be calculated in the result.
7.2.7

Use RDM

This option will enable the RDM functionality.
30