Getting Started; Connecting; First Start-Up - Oase WECS II 2048/DMX/02 Notice D'emploi

- EN -
6.3

Getting Started

Get out carefully the device out of the cardboard box and remove the packing material of the device. Place
the device on a secure underlay or screw in the device in a 19"-rack. Use a plastic wave washer for the
rack bolts, because otherwise the special spatter repelling front panel foil could be destroyed.
6.3.1

Connecting

1. Make sure you have switched off the device on backside.
2. Now connect a IEC power cord with 110/230V AC to the device
3. Connect the WECS II 2048/DMX/02 Server to your Shownet Network using the Ethernet connector
on BACKSIDE
4. Connect an USB Keyboard, Mouse or Touch Screen to one of the available USB-Ports
5. Connect a Monitor to one of the DVI connectors
6. Connect your DMX devices
6.3.2

First Start-Up

1. Switch on the Device on backside
2. Wait until the WECS II 2048/DMX/02 Server boot is finished, this can take several minutes on first
start up.
3. As soon as you can see the Info page the Server has start up completely
See Setup Network Connection to setup all Network settings to get access to your WECS II 2048/DMX/02
Server using V:PAD.
24