General Safety Rules - Wagan Tech Hi Speed Air Compressor Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Hi Speed Air Compressor

General Safety Rules

Before using our product, please check the lighter socket (12V DC
output) to make sure there is no rust or any other residue in order to
prevent any damage or danger caused by poor conductivity and power
supply overheating.
Please check the recommended air pressure of the vehicle tire and
carefully watch the pressure gauge while inflating to avoid over-inflating
your tire. The general pressure of most car tires is 2.5–3.0 kg/cm
You should start the engine when using the air compressor to make sure
the battery capacity and pump work normally.
Do not touch the metal heat sink or the air hose while in use or
immediately after use.
After 15 minutes of continuous inflation, please have the product rest for
20 minutes and restart once it fully cools down.
After use, please tuck the power cord and air hose into their locked slots
to prevent any damage to the cord or hose.
Use only 12V direct current power sockets. Do not use product with any
other type of power source.
Do not tangle the power cord together to avoid potential electrical
danger.
If the unit emits abnormal noise while in use, please stop use
immediately and check for causes and problems.
Keep away from children.
Avoid dropping the product and/or cause severe impact to the air
compressor.
Do not store or overexpose the unit to direct sunlight.
Do not use in damp areas or around flammable materials.
Do not attempt to make any modifications, disassemble or repair by
yourself or by any non-technicians.
3
by Wagan Tech
www.wagan.com
®
.
3

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

2592

Table des Matières