Table des Matières
Publicité
Staubsauger.
• Gerät ausschalten und abstecken.
• Die Abdeckung des Feinstaubsensors an der Seite des Geräts öffnen.
• Mit dem Staubsauger jeglichen Staub oder Schmutz, der sich im inneren der Kammer
angesammelt hat, aufsaugen.
AUSTAUSCH DES KOMBI-FILTERS
Der Luftreiniger verfügt über eine Filterwechsel-Erinnerungsfunktion. Soll der Kombi-Filter
gewechselt werden, leuchtet die Kontrollleuchte am Display durchgehend auf, bis der Filter
erneuert und mit „RENEW"- Taste am Bedienfeld bestätigt wird. Empfohlene Lebensdauer
des Kombi-Filters beträgt 3.000 Betriebsstunde.
• Sicherstellen, dass das Gerät ausgeschaltet und abgesteckt ist. Die vordere Abdeckung
am oberen Ende ziehen, nach unten klappen und abnehmen.
• Entnehmen Sie den Kombi-Filter inkl. dem waschbaren Vor-Filter durch ziehen der
Schlaufe an der Oberseite des Filters.
• Entfernen Sie den waschbaren Vor-Filter vom alten Kombifilter und drücken ihn wieder auf
den neuen Kombifilter
• Setzen Sie den neuen Filter inkl. waschbaren Vorfilter wieder in das Gerät ein.
• Um die vordere Abdeckung zu schließen, zuerst sicherstellen, dass die Hacken an der
unteren Seite richtig positioniert sind, bevor sie diese oben mit etwas Druck einrasten
lassen.
• Stecken Sie den Luftreiniger wieder an die Steckdosen an und schalten ihn ein. Drücken
Sie die „RENEW" – Taste am Bedienfeld für 4 Sek. um den die Betriebsdauer des Filters auf
„0" zu setzen.
FEHLERBEHEBUNG
PROBLEM
URSACHE
Der EIN/AUS-Knopf wurde nicht
gedrückt.
Das Gerät
Das Gerät ist abgesteckt.
funktioniert nicht.
Die vordere Abdeckung ist nicht
korrekt eingesetzt.
Das Ein-oder Auslassgitter ist
möglicherweise blockiert.
Verringerter
Der Filter ist möglicherweise
Luftstrom oder
verstopft.
schlechte Filterung.
Die Filter sind möglicherweise noch
immer in der Plastikverpackung.
WARNING
Reduce the risk of electric shock, injury or fire by
reading and following all warnings below. Use the
product only as described in this manual. Do not
service the product yourself.
• Do not lay the power cord under carpets or floor mats.
• Do not operate the product in a greasy environment. This
product is not intended for filtering oil or grease from
ambient air.
• Do not use the air purifier in bathrooms, near sinks or
in other wet and humid environments, near fireplaces
or areas where there may be flammable or combustible
vapours or products.
• Always disconnect the power cord from the mains when
the device is not in use, before cleaning, inserting or
removing parts and before moving it to another location.
• Never turn on the air purifier before it is fully assembled.
• Always completely switch off the device before
unplugging.
• Do not place the cord near hot surfaces.
• Never operate the air purifier if the plug or cord is or could
be damaged. Please contact customer service.
• Never use the power cord to drag, pull or lift the air
purifier.
• Do not pull the power cord around sharp corners or
edges. This can cause injury to the user or damage the
cord.
• To remove the plug from the socket, always hold the plug
itself and pull carefully. Do not pull on the cord.
• Keep foreign objects, fingers and other parts of the body,
hair, loose clothing and jewellery away from the openings.
• Never touch the air purifier or its plug with wet hands.
• This unit may be used by children 8 years of age or above,
or by persons with reduced physical, sensory or mental
capacities or lack of experience and/or knowledge, only
if they have been supervised or instructed in the safe
LÖSUNG
Den EIN/AUS-Knopf drücken.
Das Gerät anstecken.
Vordere Abdeckung schließen
und ordentlich einrasten
Sicherstellen, dass sich nichts
vor oder auf dem Gerät befindet.
Filter prüfen und wenn nötig
austauschen.
Die Plastikverpackung
entfernen.
Hergestellt in China
EN
use of the unit and can understand the hazards arising
therefrom. Children should never be allowed to play with
the device. Cleaning and user maintenance must not be
performed by children unless they are over 8 years old and
supervised. Children younger than
8 years of age are to be kept away from the machine and
the connecting cable. Extreme caution is advised when
using the air purifier near children and when leaving it
unattended.
• Please keep the device at a distance of
2 meters from televisions, radios and other electrical
devices.
• Please keep a distance of at least 10 cm from the wall.
• Place the device in a room with good air circulation.
• Do not place the device near curtains.
WARNING
• The device is equipped with a fast rotating motor. Inserting foreign objects is forbidden as
this will damage the device or cause injury.
• Before cleaning or changing the filter, please make sure that the device is disconnected
from the mains. Do not rinse or soak the filters or other parts with water. The combi-filter
is not washable. Please only replace it.
• Pre-filter - Traps larger dust particles and can be washed and reused
• HEPA filter - Removes 0.3 micron particles from the air
• The high-quality activated carbon filter removes VOCs (volatile organic compounds) and
reduces odours.
• UV light sterilization - The germicidal UV light is used to limit bacteria and viruses.
• The built-in ionizer releases the ideal concentration of negative ions to keep the air fresh.
• The device effectively removes smoke, pollen, dust, pet hair, dust mites, and much more
from the air.
USE OF THE AIR PURIFIER
Before using the device for the first time, take out the combi-filter and remove the plastic
packaging. Re-install the filter and carefully replace the front cover. Connect the device to the
mains. The device is now ready for use. Read the following instructions to choose the desired
settings.
AIR QUALITY CONTROL / PM2.5 DISPLAY (particulate matter)
The device is equipped with an air quality control that continuously monitors the
particulate matter content of the air in the room. The particulate matter content (PM2.5) is
shown as a qualitative value on the display, while 3 LED lights also provide information about
the air quality in the room.
GREEN = No particulate matter pollution
ORANGE = Low particulate matter pollution
RED = Elevated particulate matter pollution
You can set the air purifier to „Smart Auto". With this function, the device automatically
adjusts the fan speed according to the air quality (particulate matter content) in the room.
CONTROL PANEL (FIG. 1)
1.
ON/ OFF
As soon as the power button is pressed, the air purifier starts and runs in automatic mode.
The ionizer and UV function (sterilizer) are activated.
2.
Smart (automatic mode)
In smart mode, the air purifier automatically selects the fan speed and adjusts it to the
determined air quality (according to particulate matter content) of the room. If smart mode
is activated, this is indicated on the display. Pressing the ‚Smart' or the ‚Speed' button
again deactivates smart mode.
3.
Speed (fan speed)
Pressing the ‚Speed' button allows you to switch between three different fan speeds. The
selected speed is shown on the display.
4.
ION/UV
The ionizer and UV function (sterilizer) can both be deactivated and reactivated using the
ION/UV button. The display shows whether the functions are switched on or off. Note:
The ionizer and UV (sterilizer) functions can only be controlled separately via the remote
control.
5.
Lock
Pressing the ‚Lock' button once locks the entire control panel. This can only be cancelled
by means of a long press of the ‚Lock' button, which enables all controls on the control
panel again. The status of the lock function is shown on the display.
6.
Sleep (sleep mode)
When the device is in sleep mode, the fan runs at low speed and only the sleep button and
the sleep symbol on the display light up, with no other symbols being illuminated. Press
any button to cancel sleep mode.
7.
Timer
The timer function allows you to set the length of time (in hours) that the air purifier
should run before switching itself off. To do this, press the ‚ T imer' button to activate and set
it. Press the button repeatedly to choose between 1 and 8 hours.
8.
Renew
By pressing the ‚Renew' button once, the number of operating hours of the current filter
are shown on the display for four seconds. The lifespan of a filter is limited. It should be
changed every 3,000 hours. When the filter is replaced, press and hold the ‚Renew' button
for three seconds to „reset" the device (the operating time is reset to „0")
9. Remote control
Press the buttons to operate the corresponding functions
3
Publicité
Table des Matières
