Installing/ Replacing Batteries - Philips SHG8100 Mode D'emploi

ENGLISH
8
2
1
IN OUT
L L
DC 12V R R
200 mA
- +
Type: . . . .
Input: . . . .
Output: . . . .

Installing/ replacing batteries

1 Open the battery compartment door located on the left ear shell.
2
Insert 2 pieces of rechargeable batteries (Philips NiMH, AAA, SBC HB700)
3 Make sure the battery is correctly inserted as indicated by the engraved
polarity symbol in the battery compartment.
4 Close the battery compartment door.
Power up the Transmitter
5 Make sure the adapter's rated voltage indicated on the type plate corresponds
to the mains voltage supply.
6 Connect the DC power output connector of the 12 Volt/ 200mA AC/DC
adapter to the DC POWER INPUT jack at the back of the transmitter.
7 Connect the 12 Volt/200mA AC/DC adapter to the mains socket.
Always remove the adapter from the mains socket if the transmitter will not
be used for a period of time.
Charging the headphone
8 Place the headphone on the transmitter station (will also be referred to as the
"energizing docking station" in the following texts).
9
Make sure the charging contacts on the bottom of the left ear shell are well
aligned with the charging pins of the docking station.
10
The CHARGING INDICATION on front of the docking station will be
illuminated in green, and will be turned off automatically at the end of the
charging cycle.
IMPORTANT!
• Make sure you switch off the headphone before charging.
• Before using the FM gaming headphone for the first time, please
ensure that the battery is fully charged for at least 16 hours.This will
guarantee a longer operating life time of battery.
• This product complies with the latest safety regulations. Please only
charge the battery with the docking station provided, or with fully
compatible charger.