Electrical Hazards; Noise Hazards; Protective Clothing - PACLITE Equipment CUB GRINDER PSG-SEA Manuel D'utilisation

ELECTRICAL HAZARDS


ENSURE that the grinder is disconnected from electric power source and motor
operation switch is in the OFF position before removing the guards or making
adjustments.

ENSURE that the area requiring grinding does not contain any "live" electrical
cables, gas, water or communication serviceswhich may be damaged by the action
of the unit.

ENSURE that electrical cables and plugs are in good working condition before using
the grinder.

NOISE HAZARDS


EXCESSIVE NOISE can lead to temporary or permanent loss of hearing.

WEAR approved hearing protection as required by Occupational Health and Safety
regulations while operating the machine to limit noise exposure.

PROTECTIVE CLOTHING


WEAR eye protection and dust mask when working in a dusty environment.

Protective clothing and footwear may also be necessary.
ADDITIONAL HAZARDS

BEWARE of uneven or slippery work surfaces, which could create slips, trips and
falls.

EXERCISE care when working in the vicinity of unprotected holes or excavations.
SAFETY PRECAUTIONS IN OPERATIONS
The grinder has been designed to minimise noise and vibration levels and to provide
maximum operator safety. However, incorrect use of the grinder may cause serious injury,
therefore the following
precautions must be taken:
1. Do not use the grinder for longer than prescribed in your local environmental working
regulations, as the noise load from extensive daily use may result in hearing defects.
2. Always use protective earplugs or earmuffs, goggles, gloves and correct footwear.
3. Do not modify the grinder in any manner, or use a machine that has been modified by
anyone other than the manufacturer or authorised dealer.
4. Do not add weight to the machine to make the grinder work harder. Instead reduce the
number of segments on the grinding plate to increase performance.
5. Be sure that re-tipped and new grinding plates are properly balanced.
6. Do not run the grinder with grinding head raised any higher than necessary, i.e. tipped
back on handle.
7. Always be sure that folding handle latch is secure and has not vibrated loose after use.
8. When grinding, the machine is exposed to high vibration. Occasionally check for fastener
tightness
18