Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
14 Maintenance and Repair
Firstly let the unit run in position I for at least one
minute to lower the temperature to 50 degrees
Celsius.
Disconnect the mains plug from the socket and
allow the appliance to cool down completely!
If possible, clean the appliance after each use.
Use a damp cloth, on stubborn dirt use a brush.
Do not use cleaning agents such as benzine,
alcohol, ammonia, etc. These substances
attack the plastic parts.
14.1 What could be the problem if the
device does not work:
Plug is not plugged into socket:
Heating element overheated:
Weed is not destroyed:
Not close enough to the weed:
Fuel does not ignite:
In the case of faults not listed here, please con-
tact the manufacturer or our customer service
(address see warranty card).
15 Transport
The device can be adjusted for each application
so that you can work with it optimally.
•
Heat gun
•
Weed killer
•
BBQ / Firelighter (with or without extension)
Carry the device only by the provided handles.
When transporting, make sure that the device
does not get damp and that it is protected
against impacts.
22
7062768-Eurom-Multiheater-MA-1703-14.indb 22
Plug into
Allow the appliance to cool down
Wrong nozzle is used
temperature setting
Incorrect nozzle is used
Incorrect temperature setting
Nozzle not covered with fuel
16 Storage
Make sure the unit has fully cooled down before
storing.
•
Clean the device after use.
•
Store the device in a dry environment.
•
Store the device in a dust-free environment.
•
Keep the appliance away from children.
•
Keep the appliance in a dry place with a
temperature between 5 °C and 30 °C.
•
Keep the original packaging of the heat
gun.
17 Disposal
Do not dispose of electric power tools
socket
with domestic refuse. The electric power
tool is shipped in packaging to reduce
transport damage. This packaging is a raw
material and as such can either be reused or
can be fed back into the raw material cycle. The
Wrong
electric power tool and its accessories are
made from various materials such as metals
and plastics. Take defective components to a
special refuse collection point. Ask about these
at your specialist shop or local council.
14-03-17 16:04
Publicité
Table des Matières
