Parts Description; First Use - Tristar AC-5487 Mode D'emploi

pArts desCriptiOn

A. Control Panel
B. Air outlet
C. Handle
D. Water tank
B
A
C
D

first use

• Take the appliance and accessories out the box.
Remove the stickers, protective foil or plastic from the device.
• Check if the voltage of the appliance corresponds to the main
voltage of your home.
• Rated voltage: 220-240V~ 50Hz
• Place the appliance always on a stable, level surface.
Make sure there is 10 cm free air around the appliance.
This appliance is not suitable for build in.
use
• Firstly, plug in the dehumidifier.
• Press the "power" key.
8
wAter full indiCAtOr
• When the water full indicator illuminates, the tank is full.
The compressor and the fan will stop operation, please empty
the water tank.
• Remove the water tank and empty it.
• Insert the water tank back into the unit.
defrOst
• The defrost function is to ensure the unit can be operated
still under a low temperature.
• The defrost function is to defrost the ice which is created under
the low temperature.
CAutiOn
• The dehumidifier shall not operate if the humidity setting is higher
than the ambient humidity.
• Drain the water in the water storage tank when the water in
the tank is full and the water level indicator light illuminates.
Install the empty water tank back to its position, so the unit can
continue its operation.
• Thanks to the defrost function the operational temperature range
for this unit is 5-32 °C.
• If the dehumidifier does not start (the operational light does
not illuminate) or the dehumidifier stops on unknown reasons,
please check the plug and power supply for poor connection.
If the plug and power supply are in normal condition, wait for
3 minutes and restart the unit (because it takes 3 minutes
to reposition).