Pairing And Connecting; Reconnecting To The Amplifier; Power/ Bluetooth Indicator Led; Wired Connection - Marmitek BOOMBOOM 460 Guide Utilisateur

7 Pairing and connecting

The Bluetooth amplifier must be paired with your Bluetooth-enabled device in order to
be able to stream audio. To pair the amplifier, power up the amplifier (with volume
control). Then go to the wireless settings of your Bluetooth device and select "Scan for
Bluetooth devices". If in Windows, select "Add New Device" in the Bluetooth tab.
Once the amplifier is shown as a headset with the name "BoomBoom 460", confirm the
pairing on your device. Next your Bluetooth device will automatically connect to the
amplifier. If it doesn't, manually select "Connect". If streaming from Windows, note that
Windows will install drivers during the pairing. Manually connect to the amplifier by
right-clicking the headset symbol and selecting "Connect" if Windows does not connect
automatically.
After the pairing is complete audio can be streamed to the amplifier from your device.

8 Reconnecting to the amplifier

If the amplifier or your device is switched off, the connection will be dropped. When the
amplifier is switched back on, it will automatically pair to the last device it was
connected. or.you can manually reconnect to the amplifier by revisiting the Bluetooth
settings of your device. Then simply select the amplifier and select "Connect". The
audio streaming will resume. In Windows, right-click the headset symbol and select
"Connect".

9 Power/ bluetooth indicator led

The BoomBoom 460 has a multicolour indicator led. (red and green).
Red: power ON
Green: Bluetooth ON.
Red and green alternate flashing quick: Pairing mode.
Red and green alternate flashing slow: Bluetooth connection.

10 Wired connection

This BoomBoom 460 can also be used as a conventional Wired Stereo amplifier with
Direct Line-In to your Panel TV or other Audio Devices simply by connecting the
3.5mm Audio Cable from the rear of the BoomBoom 460 to your Music Source.
6 © MARMITEK