Intended Use; General Safety Instructions - Festool MX 1600/2 EQ DUO Notice D'utilisation D'origine

Original operating manual
1 Technical Specifi cations
Stirrer
Voltage
Frequency
Connected load
Idling speed
1st speed
2nd speed
Electronic speed
preselection
2-speed switch
Stirrer – max.
Clearence between
spindles
Collar –
Weight
Protection rating
2 Symbols
Double insulation
Warning of general danger
Risk of electric shock
Read the operating instructions/notes!
Wear a dust mask!
Wear ear protection!
Wear protective gloves!
Do not throw in the household waste!
Advice or tip

3 Operating equipmen
[1-1] Stirrer (not included in the standard de-
livery)
Tool mount
[1-2]
Safety pin
[1-3]
MX 1600/2 EQ DUO
220 – 240 V
50 / 60 Hz
1500 W
100 – 250 rpm
130 – 350 rpm
•
•
140 mm
110 mm
57 mm
7,3 kg
II /
t
[1-4] Lock-off switch
On/Off switch with speed control
[1-5]
Auxiliary handle
[1-6]
Speed selector switch
[1-7]
Thumbwheel for speed pre-selection
[1-8]
Accessories that are illustrated or described here
are not always included in the scope of delivery.
The specifi ed illustrations can be found at the be-
ginning of the operating instructions.
4

Intended use

The device is designed for mixing powdered mate-
rials, such as mortar, plaster, adhesives and non-
solvent paints, varnishes and similar substances.
The manufacturer accepts no liability for
possible damage or accidents caused by
using or operating the device inappropri-
ately or incorrectly.
5 Safety instructions
WARNING!
All applicable legal requirements concerning oc-
cupational safety must be adhered to, along with
the safety instructions that are cited in the section
"Safety instructions" and all other generally ap-
plicable health and working principles. The manu-
facturer accepts no liability for any damage that is
caused by unauthorised changes to the machine.
5.1

General safety instructions

WARNING!
instructions, illustrations and specifi ca-
tions provided with this power tool. Failure
to follow all instructions listed below may result
in electric shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
5.2 Machine-related safety instructions
- Before starting up any tool, you must check
the fl exible power cable and the plug. You must
have any defects fi xed by a professional.
- Never touch the machine with wet hands when
it is connected to the power mains.
- The switch must be in the OFF position before
you connect it to the mains.
- The container with the material that is to be
mixed must be stabilised to prevent it from
7
Read all safety warnings,
GB