Numark CDN25 Guide D'utilisation Simplifié page 2

1. Make sure all items listed on the front of this guide are
included in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING
THE PRODUCT.
3. Study this setup diagram.
4. Mount the units in your console or rack with 19" EIA rails.
5. The transport should be mounted not to exceed an angle of
15 degrees.
6. Make sure all devices are turned off and all faders and gain
knobs are set to "zero"
7. Connect all devices as indicated in the diagram.
8. Connect the stereo outputs to power amplifier(s), tape
decks, and/or other audio sources.
1. Open/Close: Press to load or eject the disc. The tray will not
open if a disc is in play. The tray door will automatic close in 30
seconds if left open. This is to protect the tray from accidental
damage while open
2. Single: toggles the unit to play back just one track at a time
(single) or play continuously through all tracks and then start
over repeating the CD infinitely (continuous).
3. Time: switches the time modes on the display between elapsed
playing time, remaining time on the track, and remaining time on
the total CD. When toggled to remaining time total the total
number of remaining tracks will also show.
4. LCD DISPLAY - Indicates all the functions, as they are occurring,
with the CD.
5. Track Buttons: These buttons are used to select the track to be
played.
6. Search Button: Pressing this button allows you to use the wheel
and rapidly scan the music to find a cue point. The search
function automatically shuts off after 8 seconds of non-use or you
may toggle it off.
CD PLAYER QUICK SETUP
9. Plug all devices into AC power.
10. Switch everything on in the following order.
•
•
•
11. When turning off, always reverse this operation by,
•
•
•
12. Go to
More information about this product may be found at
FRONT PANEL FEATURES
7. Cue: Returns and pauses the music at the last set cue point.
The cue point is where the music will begin when play is pressed.
The cue point is set as the initial start point on a track or can be
moved when play is started at a different point. For instance if
the music is paused then play is pressed a new cue point is set.
You can easily edit the cue point by turning the wheel during
pause. As you rotate the wheel the music will sound. By
stopping the wheel and pressing play a new point is set.
Alternately pressing the PLAY button and the CUE button allows
the CD to be played from the same position any number of times.
Note: Pressing cue 2 times plays music temporarily from this
point until the button is released.
8. Play/Pause: Starts the music from the cue point or pauses it
while in play. By pressing play after pause a new cue point will
be set
9. Jog Wheel:
Cue Function: As explained under "CUE", when the music is
paused and you rotate the wheel, music will sound. By pressing
play a new cue point is set.
audio input sources (i.e. turntables or CD players)
Mixers
last, any amplifiers or output devices
turning off amplifiers
Mixers
last, any input devices
http://www.numark.com for product registration.
http://www.numark.com