Scandyna PodSpeakers MicroPod Sub Guide De L'utilisateur page 11

MicroPod Sub switches off during the movie;
The MicroPod Sub has an automatic switch (auto standby function), which depends on the input level of the
output stage of the MicroPod Sub on or off.
The automatic system is set so that, when exceeding a certain fixed threshold value, the unit is turned on.
If this threshold is below a certain specified time, the MicroPod Sub is turned off again.
If the MicroPod Sub is switched on during the loudest passages only, you should reduce the level at the
volume control on the rear panel, to reach the same bass response, a higher level from the AV-receiver has
to come, which means that the switch has been exceeded before.
If MicroPod Sub is used in conjunction with large speakers for the front section, a change in the
AV-receivers speaker setup may help.
If the above does not help, you can choose to bypass the auto standby function by setting the switch (4)
in ON position, this leaves MicroPod Sub always on and it must be manually turned on/off by the power
switch (2) after use.
// 11