Genesis GPS080 Manuel D'utilisation page 5

to the tool or result in personal injury to the user. Consult the operator's manual for
recommended accessories.
• Keep cutting tools sharp and clean.
sharp cutting edges are less likely to bind and are easier to control
• Feed the work piece in the correct direction and speed.
work piece into a blade, cutter, or abrasive surface against the direction of the cutting tool's
direction of rotation only. Incorrectly feeding the work piece in the same direction may cause
the work piece to be thrown out at high speed.
• Never leave the tool running unattended, turn the power off.
leave the tool until it comes to a complete stop.
• Never start the power tool when any rotating component is in
contact with the work piece.
WarnIng:
USE OF THIS TOOL Can gEnEraTE anD DISBUrSE DUST Or OTHEr
aIrBOrnE ParTICLES, InCLUDIng WOOD DUST, CrYSTaLLInE SILICa DUST
anD aSBESTOS. Direct particles away from face and body. always operate
tool in a well-ventilated area and provide for proper dust removal. Use dust
collection system wherever possible. Exposure to the dust may cause serious
and permanent respiratory or other injury, including silicosis (a serious lung
disease), cancer, and death. avoid breathing the dust, and avoid prolonged
contact with the dust. allowing dust to get into your mouth or eyes, or lay on
your skin may promote absorption of harmful material. always use properly
fitting nIOSH/OSHa approved respiratory protection appropriate for dust
exposure, and wash exposed areas with soap and water.
SERVICE
Have Your Power Tool Serviced by a qualified repair person using
•
only identical replacement parts.
tool is maintained.
• Service Your Power Tool periodically.
disassemble any portion of the tool since internal wires may be misplaced or pinched.
WarnIng:
rEaD anD UnDErSTanD aLL WarnIngS, CaUTIOnS anD OPEraTIng
InSTrUCTIOnS BEFOrE USIng THIS EQUIPMEnT. Failure to follow all
instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
Properly maintained cutting tools with
.
This will ensure that the safety of the power
When cleaning a tool, be careful not to
Feed the
Do not
5