Regulatory Compliance - Acksys WLg-xROAD/S Guide D'utilisation Rapide

5 status LED display the state of the product:
LED Color
WLan
Blue
Tx/Rx(*)
Serial
Green
Tx/Rx
RS422
Green
/485
Diag(*) Red
Power Green
(*) Diag + Wlan Tx/Rx: alternative blink
This blink is meaningful only in infrastructure topology. It means that the
product did not yet associate with an access point, or WPA keys are wrong.
The unit conforms to the following European Council Directives:
N°
1999/5/CE
73/23/CE
2004/104/CE
The device has been certified to comply with the European directives and is
appropriately CE marked.
N°
EN60950
EN61000-6-2
EN61000-6-4
EN301-489-17
EN 300 328
EN 301 893
MIL-STD-810F
UTAC E2
FCC
LEDs definition
Flashing for WLAN Tx/Rx activity.
This led blinks when sending or receiving data on the
serial link.
This led is ON when you use a differential (RS422 or
RS485) electrical interface.
After power up this led stays on until the product is
operational (less than 10s).
If the led stays on steadily more than 30 seconds at
power up, the product is out of order.
After boot-up it indicates either special states
depending on the active service, or reception errors
on the serial port.
In serial port administration mode, this led blinks twice
per second, indefinitely.
This led is ON when the power supply connector
correctly powers the product.

Regulatory compliance

Radio and Telecommunications Terminal Equipment
Directive (R&TTE)
Low voltage directive
EMC for motor vehicles
Data processing devices – Security
EMC emission, industrial grade
EMC Immunity, industrial grade
EMC for radio equipment 2.4Ghz & 5GHz
Electromagnetic compatibility and Radio spectrum
Matters (ERM); Wideband transmission systems, 2.4
GHz ISM band
Broadband Radio Access Networks (BRAN);
5 GHz high performance WLAN
Shocks & vibrations according to 514.5 and 516.5
methods
CE standard for electronic equipments installed aboard
vehicle
Part 15 (Common testing standard for most electronic
equipment)
Description
Title
Title
-9-