Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.
Run the WEB configuration interface
Click on the Web button to access the built-in web-based interface from your
web browser.
In order to change the configuration you must choose the Admin user.
No password is required by default.
You are directed to a general product status page. From there you can
navigate with the general menu bar (horizontal, below the banner) and a
submenu bar (vertical, on the left). The fundamental parameters are in the
"BASIC" menu and the "Wireless" and "Serial port" submenus.
The "HELP" menu describes the parameters shown in all the other menus,
and contains a detailed glossary.
The default factory settings are:
- "Ad-hoc" mode
- SSID: "acksys"
- No security (no WEP, no WPA, no WPA2, no MAC filter)
- 802.11b/g mode
- Radio channel 6
- "Diversity" antenna mode
And for the serial port:
- Virtual COM (VIP)
- Automatic configuration (as specified by user application)
See the "Serial service type selection" section if you are unsure about
these options.
7.
If required, install VIP, the COM port redirector
Install VIP only if you meet both of the following conditions:
- You will use the product from a Windows application
- And you configured the serial service as "Virtual COM (VIP)" or (less
common) as "TCP raw port server".
VIP must be installed on the PC where the application using the virtual COM
port will run. VIP is provided on the CD-ROM.
8.
Wire the serial port
The DB9 plug from the product can be used as RS232, RS422 (4 wires) or
RS485 (2 wires). Check the kind of interface your serial equipment uses. It
must match the configuration chosen through the browser. Refer to the
"Connectors" section for wiring information.
Observe local laws when choosing
radio channels
-3-
Publicité
Table des Matières
