Safety Features And Motor Protection - Kronen KM-4 S Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Standard operation is "PULSE" button is programmed to operate at maximum speed. This
speed, however, can also be set to user's requirements. It is programmed in the same way
as the blending cycle is programmed.
- Setting desired speed in manual operation
seconds at this speed and then stop the blender by re-pressing the illuminated function
button.
- Finally press the "SHIFT" button and the "PULSE" button at the same time and
the selected speed setting will be saved.
Automatic switch off (Safety function against unintentional operation)
After 15 min. without a button being pressed, the machine stops and switches automatically to
the standby state.
After 1 hour without a button being pressed, the controller disables the buttons. This status is
indicated by the red LED on the "SHIFT" button. To continue operation, the blender must be
reset by switching the mains switch OFF and ON.
Press button combination
Press the buttons 1+2+5+6 in
succession and hold them until
LEDs light up.
Press the buttons 1+2+3+4 in
succession and hold them until
LEDs light up.
8. SAFETY FEATURES AND PROTECTION
The safety control prevents the motor from being switched on when the mixing bowl is not
in position, and stops it if the lid is raised during operation.
When the lid is mounted again, first the blender must be turned off (reset function), before the
motor can be restarted.
Only the speed control knob / main switch must be used to turn the machine on
and off.
When the machine stops automatically, immediately remove the complete
container from the motor unit, pull out the plug and turn off the machine. (e.g
power failure)
If you notice any irregularities or defects, please contact your supplier. For more informa-
tion see chapter "Repairs".
Instruction Manual
Kronen-Mixer KM-4
: Allow the appliance to operate for a few
1
Function ("AUTOMATIC" mode)
Overwrite protection of user programmes
- Save function is blocked. Programming no longer
possible.
- Blocking is lifted again with the same combination
Reset to manufacturer's settings
- All user programmed cycles are deleted.
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Km-4 bKm-4 pKm-4 pe453874538645612 ... Afficher tout

Table des Matières