Audio Connections - TECHNI-CONTACT TU-508 Guide D'utilisation

4. Position the antenna for best reception. If desired, the antenna may be permanently mounted using
screws through the two holes in the base.

Audio Connections

An audio patch cable is provided.
1. Connect the two RCA plugs from one end of the cable to the R and L STEREO terminals on the TU-
508 (for mono applications, connect one end of cable to the MONO terminal.)
2. Connect the other end of the cable to an amplifier or mixer.
OPERATION
Note: These functions are the same whether accessed from the front panel of the TU-508 or from the
Remote Control.
Power
Press the front panel POWER button to turn the TU-508.
Turn the rear-mounted VOLUME control counterclockwise to attenuate audio output and clockwise for
full output.
To Select a Band
Press the button marked AM/FM. The current band selected (AM or FM) appears on the display.
You can preset up to a total of 60 stations for both AM and FM bands combined. FM stations may be
played in either stereo or mono; press the STEREO/MONO button to change mode.
To Tune a Station
Pressing the TUNING + or TUNING- button advances to the next frequency. Pressing and holding the
TUNING+ or TUNING- button will activate the auto search feature. The word AUTO appears on the
display, and the search will continue to the next clear station signal. To stop the auto search at any
frequency, press either the TUNING+ or TUNING- button again.
To Preset Stations
1. Select a band and tune the first desired station.
2. Press the MEMORY button and then one of the CHANNEL+/-buttons to select the preset number.
The two-digit preset number appears on the display. The display flashes twice and then the preset is
stored.
3. Repeat the procedure for each desired preset.
To Scan Preset Stations
1. Press the INTRO button. Each preset station will play for a few seconds in turn while scanning.
2. To select a station during scanning, press the INTRO button again.
TU-508
6