Environmental Influences - Noblex aspherilux midi LED Mode D'emploi

Fault Remedy
If any fault occurs, such fault may be caused by a total battery discharge or
too high or too low a temperature. Therefore, it is recommended to restart
the charging after lapse of some waiting time. Such charging may be ac-
complished either by:
• pulling the plug charger (6) out of the 220V mains outlet and reconnect-
ing it; or
•
taking the NOBLEX
•
switching the NOBLEX
Please note that the battery will not be charged as long as the LED flashlight
is switched on. There will be no charging unless the NOBLEX
LED spotlight is switched off.
The contact surfaces (4) on the bottom side of the NOBLEX
LED and the contact pins at the charging (7) station should be kept clean (to
be cleaned with spirit) and protected from damage.
Battery Warning
During operation, the battery voltage is measured permanently. If such
measurement detects that the battery voltage is nearing the programmed
warning voltage, then two short flashes will be released as a visual warning
signal. This signal is sent off in switched-on condition once only. Upon re-
start and after a short pause of approximately one second, two short flash
signals will recall the warning condition. Depending on the temperature and
frequency of use, a 10 to 30 minutes operation back-up remains available.
Automatic Switch-Off and Emergency Light
When the final discharge voltage of the cells is reached, a permanent
flashing will be initiated in order to avoid total discharge. Then, the LED will
always be switched shortly with longer pauses. Thus, an emergency light
is available. To avoid permanent damage to the batteries, operation in this
condition should be limited to a minimum.

ENVIRONMENTAL INFLUENCES

When leaving the factory, the NOBLEX
aspherilux midi LED out and inserting it again; or
®
aspherilux midi LED on and off again.
®
aspherilux midi LED is waterproof.
®
aspherilux
®
aspherilux midi
®
13