Alto Professional Transport 12 Guide D'utilisation page 7

11. Wireless Mic Display: This display shows the current reception settings of the wireless
module. See Operation > Using the Wireless Microphone
12. Up/Down: Use these buttons to move to the next-highest or next-lowest channel of the
wireless module. See
13. Set: Press this button to confirm the current setting of the wireless receiver. See
Operation > Using the Wireless Microphone
14. Wireless Mic Volume: Turn this knob to adjust the volume of the wireless microphone
(included). See
15. RCA Inputs: Use a stereo RCA cable (not included) to connect an audio source to these
inputs. Use the USB/Aux Volume knob to adjust the level.
16. USB/Aux Volume: Turn this knob to adjust the volume of the RCA inputs and USB player.
This knob works in conjunction with the Vol –/+ buttons on the USB player.
17. USB Player Display: This display shows the current operation of the USB player. See
Operation > Using the USB Player
18. USB Port: Connect a USB drive with playable music files to this USB port. See
> Using the USB Player
19. Previous/Next (
are currently in the middle of a track, press Previous (
track. See Operation > Using the USB Player
20. Vol –/+: Use these buttons to lower or raise the volume of the USB player. These buttons
work in conjunction with the USB/Aux Volume knob. See
Player to learn more.
21. Play/Pause (
Using the USB Player
22. Power/Stop (
USB player. During playback, press this button to stop playback and return to the
beginning of the track. See
23. Repeat ( ): Press this button to cycle through the playback modes:
•
Normal (no indication): Tracks will play in their normal order and then stop.
•
Repeat 1 (REP 1): The current track will repeat.
•
Repeat All (REP ALL): The entire sequence of tracks will repeat.
•
Random (REP): The entire sequence of tracks will play in a random order.
See Operation > Using the USB Player
24. Line Out (1/4"/6.35 mm): Use a standard 1/4" (6.35 mm) cable (not included) to connect this
output to the input of another loudspeaker, mixer, audio interface, etc. The signal sent from
this output is a summed mono signal of all audio sources and the USB player, post-EQ.
25. EQ (Treble): Turn this knob to increase or decrease the high (treble) frequencies.
26. EQ (Bass): Turn this knob to increase or decrease the low (bass) frequencies.
Operation > Using the Wireless Microphone
Operation > Using the Wireless Microphone
to learn more.
/ ): Use these buttons to move to the previous or next track. If you
): Press this button to start/resume or pause playback. See
to learn more.
): Press and hold this button for 3 seconds to activate or deactivate the
Operation > Using the USB Player
to learn more.
to learn more.
to learn more.
to learn more.
to learn more.
to learn more.
to learn more.
) to return to the beginning of the
Operation > Using the USB
to learn more.
Operation
Operation >
7