Taking The Wallbox Emh1 Out Of Operation - ABL Wallbox eMH1 Mode D'emploi Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35

Taking the Wallbox eMH1 out of operation

In case of severe malfunctions or damage to the device, you must take the Wallbox eMH1 out of opera-
tion. To do so, proceed as follows:
Wallboxes eMH1 with integrated RCCB only:
1
Open the housing cover of the wallbox using
the key supplied and flip it up.
2
Flip the pivot lever of the internal RCCB to
the 0 position.
3
Close and lock the housing cover of the
wallbox.
All Wallboxes eMH1:
4
Open your domestic power distribution box
and disconnect the power supply cable from
the electricity grid.
y Wallboxes without integrated RCCB:
In addition, flip the pivot lever of the
RCCB to the0 position.
y Close the domestic power distribution
box.
The Wallbox eMH1 is no longer connected to the electricity grid and can be removed by a qualified spe-
cialist electrical contractor if required.
Danger
Dangerous electrical currents
Always measure the voltage between the phases and the neutral conductor of the power supply cable
before you start dismantling the wallbox.
Wallbox eMH1 – Taking the Wallbox eMH1 out of operation
|
25

Publicité

Table des Matières
loading

Table des Matières