Troubleshooting; Changing A Fuse; Other Possible Problems - Dolphin 12V25/18A Manuel D'installation Et D'utilisation

EN

TROUBLESHOOTING

Changing a fuse

Before replacing a fuse, it is important to investigate the cause of the fuse blowout
beforehand.
To check a fuse, the following procedure must be followed:
• Switch off the power supply.
• Disconnect the power connector
• Remove the fuse by gently pulling on it.
• Test the fuse with a multimeter.
• If necessary, replace the fuse with a new fuse of the same amperage.
• Insert the new fuse.
• Reconnect the power connector.
• Reconnect the power supply.
• Check that the system is working properly.

Other possible problems

Check the type of fault (see chapter «Front panel LED» and if necessary, contact the
dealer to activate the service procedure.
29
ATTENTION
NOT-BOOSTVDLEVO2-02