Operating The Trimmer - Haussmann 8401022 Manuel D'utilisation

OPERATING INSTRUCTIONS
Always disconnect the trimmer before making
adjustments!
Figure F
7. SELECT AN EXTENSION CORD
Use only a voltage supply as specified on your
unit.
Extension Cord Gauge Cord
Length of Cord
25 Ft. (7.5m)
50 Ft. (15m)
100 Ft. (30m)
Extension cords are available for this unit.
8. MAINS SUPPLY CABLE STRAIN RELIEf
(SEE fIG G)
In order to reduce strain on the cable inlet,
form a loop and locate the cable around the
strain relief arm.
Figure G
A
18
Gauge
18 Gauge
16 Gauge
16 Gauge
OPERATION

1. OPERATING THE TRIMMER

Caution: Always wear eye protection.
1) To switch on the trimmer, press the On/Off
switch, release to stop (See Fig H).
Figure H
2) Use the trimmer at an angle of
approximately 20 to the working area
o
(see fig I).
3) Slowly swing the trimmer from side to side
(see fig J).
4) Do not overload your trimmer, take small
passes - this will keep your tool operating at
high speed and will greatly improve cutting
efficiency, (see fig K and fig L).
5) Cutting edges
You can use the edge guide to assist in
guiding the trimmer along an edge. (see Fig N)
6) Cutting close to a wall
Use the outside edge of the guard as a guide
when cutting close to an edge.(see Fig O)
Figure I