Table des Matières
Publicité
EN
USER MANUAL
All the hearing protectors which are included
in this instruction sheet are equipped with a
thermoplastic headband or spring-arms, or
stainless-steel neckband and foam plastic filled
cushions. This hearing protector is intended
to protect the wearer from hazardous noise
levels when fitted in accordance with these user
instructions. Any other uses are not intended and
therefore not allowed.
Hereby, Zekler Safety, declares that the hearing
protector Zekler is in compliance with PPE
Directive 89/686/EEC, PPE regulation EU
2016/425 and other appropriate directives to fulfil
the requirements of CE marking. The full text of
the EU declaration of conformity is available at
the following internet address:
www.zekler.com/Declaration-of-conformity
For manufacturing date, see the date clock on
the inside of the ear cup. Expected lifetime of
product is 5 years.
For traceability, see the date clock on the inside
of the earcup.
Warning!
It is important that the instructions for use are
followed. Failure to do so could result in a drastic
reduction in the noise attenuation and may lead
to serious injury.
Carefully read these user instructions!
• The hearing protector must be used at all times
in noisy environments to provide the full
protection effect! Only 100% wear time provides
full protection.
• The audibility of warning signals at a specific
workplace may be impaired if over protected,
when using a hearing protector with a too high
noise attenuation performance in relation to the
noise environment.
• Certain chemical substances can have a
destructive effect on this product. More
information is available from the manufacturer.
• Ensure that the hearing protectors are regularly
inspected for serviceability.
• The hearing protector's noise attenuating
properties can dramatically decrease with
usage of for example thick spectacle frames,
ski masks/balaclavas, etc.
• Use of perspiration/hygienic protection over the
sealing rings can reduce the hearing protector's
noise attenuation properties.
• Earmuffs, and in particular cushions, may
deteriorate with use and should be examined at
frequent intervals for cracking and leakage.
• Immediately discard the product if showing
signs of cracks or damage.
• Hygiene kit should be changed at least twice
per year. Make sure you choose the correct
hygiene kit for your hearing protector.
• Clean the product with mild soap. You must be
sure that the detergent you use does not irritate
the skin. Do not dip the product in water.
• The hearing protector must be stored in a dry
and clean environment out of direct sun light,
e.g. in its original packaging.
Fitting & adjustment (A)
Brush away all hair from the ears and place the
hearing protectors over the ears so that they fit
comfortably and snugly. Ensure that the
ears are completely enclosed by the hearing
protectors and that you have even pressure
around the ears.
Headband (A1)
Adjust the headband size so that it rests lightly
against the crown of your head.
Neckband (A2)
Adjust the protector to its largest size and put it
on. Now adjust the headband strap so that the
protector rests lightly on your head.
Helmet/Cap mount (A3)
Push the hearing protectors helmet attachment
into the helmet slot until it locks into position.
Place the hearing protectors over the ears and
press inwards until you hear a click. Adjust the
hearing protectors and helmet so that they fit
comfortably on your head.
8
Publicité
Table des Matières
