Electrical Requirements - Franke FGA 364 W Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

• Venting system MUST terminate outside the home.

• DO NOT terminate the ductwork in an attic or other enclosed space.

• DO NOT use 4" laundry-type wall caps.

• Flexible-type ductwork is NOT recommended.

• DO NOT obstruct the flow of combustion and ventilation air.

• Failure to follow venting requirements may result in a fire.

A 120 volt, 60 Hz AC-only electrical supply is required on a separate 15 amp fused circuit. A

timedelay fuse or circuit breaker is recommended. The fuse must be sized per local codes in ac-

cordance with the electrical rating of this unit as specified on the serial/rating plate located inside

the unit near the field wiring compartment. THIS UNIT MUST BE CONNECTED WITH COP-

PER WIRE ONLY. Wire sizes must conform to the requirements of the National Electrical

Code, ANSI/NFPA 70 - latest edition, and all local codes and ordinances. Wire size and connec-

tions must conform with the rating of the appliance. Copies of the standard listed above may be

obtained from:

This appliance should be connected directly to the fused disconnect (or circuit breaker) through

flexible, armored or nonmetallic sheathed copper cable. Allow some slack in the cable so the ap-

pliance can be moved if servicing is ever necessary. A UL Listed, 1/2" conduit connector must

be provided at each end of the power supply cable (at the appliance and at the junction box).

When making the electrical connection, cut a 1 1/4" hole in the wall. A hole cut through wood

must be sanded until smooth. A hole through metal must have a grommet.

WARNING - TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,

any solid-state speed control device.

WARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO

PERSONS, OBSERVE THE FOLLOWING:

turer. If you have any questions, contact the manufacturer.

Before servicing or cleaning unit, switch power off at service panel and lock the service discon-

necting means to prevent power from being switched on accidentally. When the service discon-

necting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the

service panel.

CAUTION:

For General Ventilating Use Only. Do Not Use To Exhaust Hazardous or Explosive Materials

and Vapors.

W A R N I N G