In case of improper usage or if you have opened, altered and repaired the product yourself,
all guarantees expire. The supplier does not accept responsibility in the case of improper
usage of the product or when the product is used for purposes other than specified. The
supplier does not accept responsibility for additional damage other than covered by the
legal product responsibility.
2. INTRODUCTION
The VideoLink ADVANCED enables you to transmit a video signal from your VCR, Satellite
receiver, Cable box, DVD-player, DVD-recorder, Satellite receiver, set top box, PC etc. to a
(second) TV without running wires. The transmitter sends an Audio/Video signal from 2
different sources to the receiver via 5.8GHz radio frequency signals. The receiver converts the
radio signal back into an A/V signal. The receiver also converts the infrared signals sent by
the remote control of the A/V source into radio frequency signals. The transmitter will then
reconvert these signals into infrared signals in order to control the connected A/V devices.
Using the 5,8GHz frequency, you will normally have no problems with distortion from wireless
(WiFi) networks, Cordless phones and microwave for example.
3. SET CONTENTS.
1 Transmitter
1 Receiver
2 Power Supply adapters
1 IR Extender cable with 3 LEDs.
1 3,5 mm jackplug / RCA adapter (audio)
3 Mini-DIN / RCA cables (white / red / yellow). 1 User manual
4. LEGEND:
(Pictures on page 4-6)
Transmitter
Mini DIN input 'AV IN 1'
Mini DIN input 'AV IN 2'
DC input 7,2V 320 mA
Mini DIN output AV OUT
Source selection Switch ½ (LOCAL SELECTOR)
Output for infrared extender IR EXT.
Audio/Video transmitter aerial
IR transmitter antenna
Operating LED
On/OFF switch
Channel switch A/B/C/D
5. SETTING UP THE TRANSMITTER
See figure 7 on page 7.
The transmitter can be connected to two A/V devices and a local television set.
1. Connect the RCA/RCA cable to the 'A/V IN 1' or the Mini-DIN/RCA cable on the 'A/V IN 2'
of the transmitter.
20-11-2009
1 RCA cable (white / red / yellow)
2 SCART adapters (labelled Transmitter).
1 SCART adapter (labelled Receiver)
1 SCART adapter (labelled AV OUT).
1 UHF Coaxial cable
Receiver
Mini DIN output AV EXTEND
UHF/RF Coaxial output
DC input 7,2V 250mA
Audio/Video receiver aerial
IR transmitter antenna
Operating LED / infrared receiver
Source selection Switch ½
ON/OFF switch
Channel switch A/B/C/D
10
033000=14888C