Downloading The App; Bluetooth Pairing - Denon Professional DELTA 15 Guide D'utilisation

Using the Live Drive App
Delta Series loudspeakers also come equipped with wireless technology and the unmatched
capabilities of the Alto Professional Live Drive wireless speaker app. You'll be able to level-
match, adjust EQ and compression, compensate for delay, and more. The Delta Series puts
active live sound control at your fingertips. Using the app on your iPad, iPhone, or iPod touch,
you can adapt the speakers to new venues or tweak settings remotely from any corner of the
room. Delta Series loudspeakers offer a powerful new experience, not only for your audiences,
but also for you—you get streamlined, sound-shaping capabilities at your fingertips.

Downloading the App

To download the App, just search for Live Drive in the App Store and download the Alto
Professional Live Drive app.

Bluetooth Pairing

About Range: Delta Series loudspeakers use an advanced, extended-range Bluetooth
antenna design, allowing for ranges far greater than traditional Bluetooth devices. The typical
range is approximately 100 feet (30 meters) with a clear line of sight. However, the range may
vary depending on your source device and the environment.
To maximize the range:
•
Set your source device on a flat surface and make sure there are no obstacles between
the loudspeaker and your device (e.g., walls, furniture, etc.).
•
Turn off your source device's Wi-Fi.
•
Turn off any unneeded 2.4 GHz devices in the nearby vicinity (e.g., other Bluetooth
devices, baby monitors, Wi-Fi access points, microwave ovens, etc.).
•
Try using a different Bluetooth source device (iPad, iPhone, or iPod touch). Bluetooth
signal strength varies between different devices.
To pair the speaker to your Bluetooth device:
1. Do this on one loudspeaker only: With the loudspeaker powered on, press and release its
Pairing Button. Its Pairing LED will flash.
2. From your Bluetooth device's settings page, enable Bluetooth and select Denon
Professional as the device. When paired successfully, the Pairing LED will light
continuously. (This process may take up to 30 seconds.)
Important: If your device prompts you to enter a PIN code to pair it to the speaker, enter
0000 (four zeros).
3. Once your device is paired to the speaker, the speaker will remember the device even
after power-cycling it. If the device does not reconnect automatically, go to your device's
Bluetooth settings page and select Connect to reestablish the connection.
To erase all previous pairing and linking settings, press and hold the Pairing Button for 10
seconds. The LED will also flash to confirm the pairing records are erased. Now, you can pair
to a new device.
Live Drive Operation
For more information about using Live Drive, visit altoprofessional.com/livedrive.
5