Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
Place your appliance on a floor that is strong enough to support the
appliance when it is fully loaded. To level your appliance, adjust the front
legs at the bottom of the appliance.
Do not expose the device to direct sunlight.
Do not place near heaters, next to a stove or any other heat sources.
Only install at a location with an ambient temperature suitable for the
climate class of the device.

Electrical connection

Warning: Improper use of the grounded plug can result in the risk of
electrical shock. If the power cord is damaged, have it replaced by
an authorized service.
The plug, together with the grounding conductor, must fit into the wall
socket.
The mains plug must be freely accessible.
Do not cut or remove the ground wire from the power cord supplied under
any circumstances.
Use of extension cords is not recommended.
The cord should be secured behind the wine refrigerator and not let
exposed or dangling to prevent accidental injury.
Operation
Prior to first use
IMPORTANT: Before connecting the appliance to the power source, let
it stand upright for approximately 2 hours. This will reduce the possibility
of a malfunction in the cooling system from handling during
transportation.
IMPORTANT: In case you disconnect the device or in case of power
failure: Wait for 5 minutes before restarting the device.
Clean the interior surface with lukewarm water using a soft cloth.
It is recommended that you install the wine refrigerator in a place where the
ambient temperature is between 10-26°C. If the ambient temperature is
above or below recommended temperatures, the performance of the unit
may be affected. For example, placing in extreme cold or hot conditions
may cause interior temperature to fluctuate. The range of 11-18°C may not
be reached.
4
Instructions for use

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Wc-18b.003b

Table des Matières